Beams on!

These past few days we have been aligning, cutting and fitting the beams.  We taped the hulls together and put them back in to the jig and cut holes where the beams enter so they can bond together with the bulkheads.  The beams were glued in and sanded and yesterday we finished it with carbon over top of the beam and onto the bulkhead, bonding the beams to the bulkhead.  Tomorrow we will make a daggerboard trunk and place g10 backing plates for the hardware.

fitting the beams, cutting holes in deck

beam with filler 

inside of the hull

Hull in the jig